Weight: 2.0 (in Kg)
These direct drive three-way, two-position vacuum solenoid valves feature conical shutters servo-controlled by the vacuum. They are normally closed as standard, but they can be supplied normally open upon request. They are composed of an anodised aluminium body where the connections are located, two silicone shutters assembled onto a stainless steel stem and a membrane in special reinforced compound. A solenoid pilot valve activated by a built-in electric coil manages the vacuum at the servo-control. The operating principle of these solenoid valves is based on the pressure differential between the vacuum pump or generator and the pressure of the suctioned air. By addressing this “differential pressure” to the servo-control via the solenoid pilot valve, the shutters can be controlled without compressed air or springs. Due to their operating principle stated above, they are not recommended on plants with rough vacuum levels (below 850 absolute mbar, equal to 15 % vacuum).The lack of springs, frictions and internal dynamic stresses favours a high response speed and guarantees long lasting operation. The electric coils of the solenoid pilot valve are fully plastic-coated in synthetic resin, watertight, insulation class F (up to 155°C) as per standard VDE, with 3 mm two-terminal electrical connections for connectors in compliance with EN 175301-803 (ex DIN 43650) - C. Protection degree IP 54; IP 65 with connector inserted. Available for voltages 12-24V/50-60Hz and 12-24VDC. Tolerance permitted on the nominal voltage value: ±10%. Maximum electric power: 2 W The connector can be rotated 180° on the coil and can be supplied, upon request, with LED lights, anti-interference circuit and/or with protection devices against overvoltage and polarity reversal. A push-button device, built-in the solenoid pilot valve, allows manually opening and closing the solenoid valve. The solenoid valves in this series, along with the uses described for the 07 .. 11 series, can be used on plants with no compressed air. The solenoid valve must be always chosen according to the flow rate and, therefore, to the vacuum pump or generator suction connection. Technical features Operating pressure: from 0.5 to 850 absolute mbar Temperature of suctioned fluid: from -5 to +60°C Product codes: 070343NC 070343NO 070443NC 070443NO 070543NC 070543NO
Sed ut perspiciatis, unde omnis iste natus error sit voluptatem accusantium doloremque laudantium
View All Categories
Instrumentation.jpeg)
Valves
Temperature
Sensors
Pneumatics
Hydraulics
